Carthago Door Catches

Carthago door catches have a tendency to break apart. This can happen in two ways. The first is for the SADDLE shaped section that screws to the door splits in half. The second is for the hooky part to break.

I have have designed 3D printed improvements for both these situations. They are printed in PETG in a brown as close to the original colour as can find.

OPTION 1. To address the broken SADDLE, I have 3D printed a beefier replacement SADDLE. The existing hooky part is reused and you fit the new SADDLE. The existing screw holes are kept, so you don’t need to drill new ones in a different place. This is Β£15+P&P Β£3.75 for a pack of 6 SADDLES.

OPTION 2. To address the broken HOOKY PART, I have designed a complete replacement. (SADDLE & HOOKY PART). Again the hole positions are in the same place, so the replacement fits straight in without drilling new holes. This is Β£15+P&P Β£3.75 for a pack of 2 catches.

Obviously option 1 is the most cost effective route to take as long as your HOOKY PART is in good condition. Option 2 is there if you however need the whole catch, but they do take longer to print and I have to hand assemble them. Pictures below to help with your choice. If you are unsure just email me with pictures of your catches.

Email us on chrisatheathpark@yahoo.com to order.

< Return to full product catalogue.

SADDLE OPTION 1

Complete Catch OPTION 2

< Return to full product catalogue.