Projects Gallery
This is my gallery of one off designs that I have been asked to make.
Need that special part that’s just not available any more, or was made really flimsy in its original design.
Email us on chrisatheathpark@yahoo.com
< Return to full product catalogue.
All Projects printed on my little fleet of Prusa Printers
.
.
.
Hymer Motor home Waste tank roof vent covers with insect mesh
.
.
.
Water Drain Valve cover to stop it getting knocked and draining all your precious water.
.
.
.
Holders for telescope eyepieces in your observatory. They have vent meshes at the bottom. Not for motor homes really, but it was a project.
.
.
.
Calibrated motor home level. Levels your motor home perfectly every time at a glance.
.
.
.
New Striker plate for Hymer window that used to rattle. New design held window more securely and stopped annoying rattle
.
.
.
Eggs Holder for the Dometic RMS8501 Fridge Door. Slots into the existing top door shelf. Has soft removable liners to cradle the eggs, keeping them nice and secure. Along the back EGGS written in popular European languages just to add a little playfulness.
.
.
.
.
AutoTrail BodyTrim. Printed in ASA, sanded and painted in the same colour as the body. Indistinguishable from the original, only stronger.
.
.
.
Locking finger to prevent the cupboard roller shutter dropping down on you while searching through your cupboard.
.
.
.
LPG Cap replacing the ridiculously stiff original. I made a special key-way that locks into the LPG recess for removing. (upper picture). For a direct replacement of the original cap this is shown in the bottom picture. The external diameter is slightly smaller so it isn’t stiff to remove like the original, and the finger grip is undercut to get a better purchase when removing.
.
.
.
Habitation door latch striker plate cover in gray to replace the flimsy original that cracked. Original made by Zadi to fit Weinsberg German Motorhome from the Knaus/Tabbart group. (images above)
.
.
.